04. Display stand

4-1. Included items

dm2_stn2_included items_EN

  • Grip pole
  • Trigger pole
  • Hex Screw(M3)
    • 2 pieces
  • Hex wrench
  • Display stand base
  • Dummy battery
  • USB Type-C cable
  • Quick setup guide / Warranty

4-2. How to assemble

1. Attach each pole to the stand base.

Insert each pole into the hole in the display stand base.
Slowly tighten the screws from the bottom to secure it in place.
Use the included hex wrench to secure the hex screws.

dm2_stn2_assemble_1_EN

2. Adjust the mounting angle.

Check that each pole is fixed perpendicular to the stand base when viewed from above.
*If the poles are not fixed perpendicularly or the screws are not tightened properly, the DOMINATOR may fall down.

dm2_stn2_assemble_2_JP_EN

4-3. Placing DOMINATOR

1. Install the dummy battery.

Install the included USB Type-C cable to the dummy battery and insert the dummy battery in the same way as the battery included with the device.
Remove the rubber cap and expose the dummy battery cable.

dm2_stn2_placing_1_EN

2. Place DOMINATOR on the stand.

As shown in the diagram below, place the step of the trigger part of the DOMINATOR on top of the trigger pole.
Rotate the top of the trigger pole and secure it so that the grip rests on the grip pole.

dm2_stn2_placing_2_JP_EN

dm2_stn2_placing_3_JP_EN

Make sure:

  1. The DOMINATOR is parallel to the stand.
  2. Placed in the center of the anti-slip rubber on each pole.
* If not placed correctly, the DOMINATOR may may fall down.

3. Connect the power cable.

Connect the dummy battery USB Type-C cable to the USB Type-C AC adapter.

Set DOMINATOR to display mode, and plug it into a power outlet and DOMINATOR will boot automatically.

dm2_stn2_placing_4_EN

4-4. Power Supply

This product requires a power supply that operates via USB Type-C.

As a power supply, you can use a commercially available AC adapter that meets all of the following requirements.

  1. The power output connector must be USB Type-C
  2. Capable supplying current up to 3.0 amps at 9 volts DC
  3. Compliant with USB Power Delivery standard

It cannot be used if the power supply cannot output 3.0 amps at 9 volts even if even it complies with the USB Power Delivery (USB PD) standard and can supply more than 27 watts.

An AC adapter with multiple output ports, it may not be possible to output 3.0 amps even at 9 volts when multiple output ports are used simultaneously or depending on the type of output port.

Please check and make sure the AC adapter’s instruction manual and the specification before use.

4-5. Compatible AC adapter

  • Anker
    • Anker 323 Charger (33W)
    • Anker Nano II 65W
  • AUKEY
    • PA-C2-GY
  • BUFFALO
    • BSACPD6505C2BK
  • ELECOM
    • EC-AC14BK
  • SANWA SUPPLY
    • ACA-PD80BK
  • TAMA ELECTRONICS INDUSTRY CORP.
    • PR-AP153UC